I colored the drawings below with Petalica Paint:
UPDATE: I laser cut the portrait above at Quelab, but it did not print well on the Tortilla Press. Part of the problem was the dots that made up the grey area {a result of the Floyd Steinberg pattern in XnView -- Image/Conver to Binary/Binary (Floyd Steinberg)}. The dots were too thin and high, and broke off easily when I washed the linoleum plate. Maybe if I first converted the image to 175 DPI, it would laser cut better.
- John Tollett's drawing from the same session
Linoleum
I first drew on linoleum squares, then scanned and colored them in Deep Dream Generator.
Cut
Simulation of what the print would look like
Update: Printed on the street during the August downtown ABQ ART WALK:
Simulation altered in Deep Dream Generator
No comments:
Post a Comment
Note: only a member of this blog may post a comment.